주요특징
| M9386 (EtherCAT ID Type Network Adapter) | |
Adapter Type |
Slave Node (EtherCAT) |
| Protocol | EtherCAT |
| Max. Expansion Module | 63 slots |
| Max. Data Size | Max 128 bytes each slot |
| Max. Network Node | 65,535 |
| Baud Rate | 100Mbps |
| Bus Connection | 2 x RJ-45 |
| Mac Address / IP Address | Not needed |
| Other Serial Port | RS232 for MODBUS/RTU, Touch Panel or IOGuide(Crevis Software) |
| Serial Configuration (RS232) | Node : 1 (Fixed) Baud Rate : 115200 (Fixed) Data bit : 8 (Fixed) Parity bit : No parity (Fixed) Stop bit : 1 (Fixed) |
| Indicators | 4 LEDs 1 Green/Red, Module Status (MOD) 1 Green, Network Status (RUN) 1 Red, Error Status (ERROR) 1 Green/Red, Expansion I/O Module Status (IOS) 2 LEDs (each RJ45 Connector) 1 Yellow, Link/Active 1 Green, Not used |
| Module Location | Starter module left side of M-Series system |
| General specification (Supplied by M7001) | |
| UL System Power | Supply voltage : 24Vdc nominal, Class 2 |
| System Power | Supply voltage : 24Vdc nominal Supply voltage range : 15~28.8Vdc Protection : Output current limit, Reverse polarity protection |
| Power Dissipation | 70mA typical @ 24Vdc |
| Current for I/O Module | 2.0A @ 5Vdc (If except for NA, current for I/O module is about 1.5A) |
| Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation |
| UL Field Power | Supply voltage : 24Vdc nominal, Class 2 |
| Field Power | Supply voltage : 24Vdc typical (Max. 28.8Vdc) * Field Power Range is different depending on IO Module series. Refer to IO Module`s Specification. |
| Max. Current Field Power Contact | DC 10A Max |
| Single Wire | 0.205㎟ - 1.3㎟ (24-16 AWG) |
| Torque | 0.8Nm(7 lb-in) |
| Weight | 179g |
| Module Size | 54mm x 110mm x 75mm |